How to hang a bear rug on the wall
Method 1: using pre-installed rings or tabs
This is the most common and secure method for hanging a taxidermy rug. It utilizes the mounting points provided by the taxidermist, ensuring the weight is distributed correctly across the hide.
detailed hanging process
First, lay the bear rug flat on the floor directly below where yuo plan to hang it. helps you visualize the final placement, This does. Carefully measure the distances between the hanging rings or tabs on the rug. Focus on the main weight-bearing points, typically one or two near the head and one on each shoulder or front leg.
Next, use your stud finder to locate the studs in your wall. It is always best to anchor... Transfer your measurements from the rug to the wall, using a level to ensure your marks are perfectly aligned. sort of, mark each spot where a screw will go.
Drill small pilot holes at your marked locations. Then, drive your screws into the pilot holes, leaving them protruding about a half-inch from the wall. With the help of a friend, carefully lift the rug and hang each D-ring or tab securely onto a corresponding screw. Adjust as needed until the rug hangs flat and looks natural, right?
Preparation: before you begin (well, almost)
Properly hanging a bear rug is crucial for preserving its quality and ensuring it remains a stunning centerpiece. Before you drill any holes, take the time to prepare both the rug and the wall, right? This initial step will prevent damage and make the hanging process much smoother.
Assess your rug and gather your tools
First, inspect the back of your bear rug. kind of, most professionally prepared rugs will have a double-felt backing. Look for heavy-duty D-rings or strong fabric tabs sewn into the felt liner, especially around the head, shoulders, and legs, right? These are the intended mounting points. If your rug lacks these, you may need to consider an alternative method. if you ask me, next, choose the great wall space. kind of, avoid areas with direct sunlight, which can fade the fur, or near heat sources like fireplaces, which can dry out and damage the hide, right?
Once you have a location, gather the necessary tools:
- Tape measure
- Pencil
- Stud finder
- Level
- Drill with appropriate bits
- Heavy-duty screws or wall anchors
- in fact, a friend to help you lift and position the rug or rather
Method 2: the tack strip method
If your rug does not have built-in hanging loops, the tack strip method is an excellent alternative. This technique, commonly used for installing carpets, creates a secure, nearly invisible mount that gives the rug a "floating" appearance against the wall.
so, creating an invisible mount
Purchase wooden tack strips from a hardware store. well, you will need to cut them into smaller sections that can follow the general outline of the upper part of your bear rug (head and front legs). I think, the goal is to create a framework on the wall that the rug's felt backing can grip onto, right?
Using a hammer or nail gun, attach the tack strips to the wall with the sharp tacks pointing upward and slightly out from the wall (at about a 45-degree angle). just saying, make sure these strips are securely fastened, preferably into wall studs.
Once the strips are in place, lift the rug and firmly press the felt backing onto the sharp tacks. Start at the top center (the head) and work your way outwards towards the legs., you know what I mean? tacks will grip felt material, holding the rug tightly against the wall without any visible hardware.